Tag Archives: plastics technology

  • Plastics manufacturers are all too familiar with the challenges of bonding thermoplastics. Last week, BTG Labs successfully hosted a webinar with Plastics Technology to discuss improving bonding of thermoplastics. The webinar, entitled “Understanding Surface Energy: How to Measure and Control the Surface Properties of Thermoplastics to Maximize Adhesion,” brought in almost 400 registrants.

    Presented byBTG Labs’ Chief Scientist Dr. Giles Dillingham who discussed the surface characteristics of thermoplastics. Dr. Dillingham also explored surface treatment processes such as flame, corona, and plasma, and ways to monitor and verify those processes. The ability to understand and measure the surface precisely is the key to successfully bonding thermoplastics.

    This table shows the relationship between low surface energy and relative interfacial toughness. While thermoplastics are highly durable, they cause difficulties in bonding because of their low surface energy.

    …Read More

  • Every plastics manufacturer knows that bonding low energy thermoplastics can be challenging. In the upcoming webinar hosted by Plastics Technology, BTG Labs’ Chief Scientist Dr. Giles Dillingham will discuss practical ways to improve bonding of thermoplastics more reliably and efficiently.

    Dr. Dillingham will discuss the nature of thermoplastic surfaces and how the manipulation of various surface treatment processes—flame, corona, and plasma—make or break a surface. The webinar will discuss how the Surface Analyst uses water contact angle measurements to lend imperative insight into surface energy and in turn, hone in on the necessary treatment level for a higher quality, more consistent manufacturing process. After all, the most expensive surface treatment is nothing without an in-place monitoring process. …Read More

  • New Paper Presented at ANTEC 2017

    by Emily Walsh May 2017

    Last week, BTG Labs exhibited and presented at ANTEC 2017. We were pleased to connect and exchange intelligence with leaders in the plastics industry.

    Our booth featured the Surface Analyst, which uses contact angle to measure surface cleanliness of a material. This monitors the surface preparation process and ensures readiness to bond, print, paint, coat, or seal which can be challenging on plastics. More and more, plastics manufacturers are turning to the Surface Analyst for guaranteeing their surface treatment and final product.

    Along with exhibiting, BTG Labs’ Chief Scientist Dr. Giles Dillingham presented the paper, “Rapid Evaluation of Surface Properties of Medical Tubing for Process Development and Quality Assurance.” The paper explains that the key to manufacturing high performance medical devices is understanding and controlling surface properties. Crucial characteristics of medical tubing such as wettability, adhesion, antithrombogenicity, and biocompatibility depend on only the top few molecular layers of a surface. Dr. Dillingham discusses research done with the Surface Analyst for highly sensitive surface measurements on medical tubing to control coating application. …Read More