Water break is a common test for surface cleanliness. It allows the user to test for the presence of hydrophobic contaminants, which can be detrimental to adhesion. It is usually considered non-destructive to the part because it uses only water.
To perform a water break test in accordance with the ASTM-F22 Handbook, the material is dipped in water and withdrawn vertically. The behavior of that water on the surface reveals the surface energy which is determined by the cleanliness level. If the surface is clean it will show high surface energy and the water will spread out due to its attraction to the surface. This strongly correlates to adhesion ability. Water break is mostly used on metals to expose the presence of contaminants or after surface processes such as etching, anodizing, painting, priming, coating, grit-blasting, or sanding. However, these tests can be messy and sometimes can result in unintended contaminating due to impure water. The user must also allot a significant amount of time for the part to dry after the test. These tests require a trained user who can determine a “go” or “no go” result. This leads to subjectivity. Lastly, the test can lack sensitivity as a surface can visually appear clean, when it’s not.
In contrast, the Surface Analyst™ is sensitive to the top 2-3 molecular layers of a surface. By using a single drop of highly purified water, there is virtually no mess and no threat to the measurement surface. Furthermore, it’s a small, handheld, user friendly instrument, that has the ability to measure on almost any surface or surface orientation, regardless of shape or roughness. The automatic calculation of contact angle removes operator subjectivity. The Surface Analyst measures on a cleanliness scale as opposed to a binary go/no go result. So measurements taken with the Surface Analyst can more closely map out a surface’s characteristics.